Puffin SwiftAssemblyandUser InformationScanSport, Inc. / Pakboats234 May StPost Office Box 700Enfield, New Hampshire 03748 USAPhone: (888) 863-9500 (t
– 2 –Figure 1, PartsFigure 2, Assembled (deck removed)Cross Ribs(A)(B1) (B2)(C)(C)(D)(D)StemStem(E)(F)(F)Air ValveBoat SkinKeelGunwalesDeckSeatForwar
– 3 –1. Roll out the boat skin and assemble all therods.2. Insert both gunwales as far as they will go.Close the black flaps to cover the ends.3. Ass
– 4 –9. Inflate upper air tubes just enough to give alittle pressure. Inflate lower air tubesalternately until they feel hard (about as muchas you ca
– 5 –The Puffin Swift is now complete.16. Mount support rods (E)17. Mount support rods (F).18. Hook “short” end of deck over the stern(boat’s rear en
– 6 –➜ Undo all the hook and loop fasteners before you try to get the ends of the deck off.➜ Open the air tube valves .➜ To remove the gunwales:• Op
– 7 –General InformationStorage Your Puffin Swift is equally happy stored assembled or packed in the bag.Salt Water Following exposure to salt water,
ScanSport, Inc. / Pakboats234 May StPost Office Box 700Enfield, New Hampshire 03748 USAPhone: (888) 863-9500 (toll free)From outside the US: +1 (603)
Commentaires sur ces manuels